The REV2 Carbon is new for 2020, and is currently the lightest head and neck restraint available. The Medium 2" tips the scales at less than 1 pound! The simple, small, easy to use design carries over from the popular REV2 Lite, and has the same level of certification and safety as all NecksGen head and neck restraints. The adjustable tether makes setting your slack and range of motion quick and simple. No need to worry about your seat angles or fiddly straps around your chest. Just put your belts on and go. Available in sizes to fit most all drivers, you just have to decide if you prefer the shiny gloss finsh, or the beautiful matte finsh (Shown here). Quick release helmet hardware is always included with all NecksGen head and neck restraints.
*Due to high demand, most of the second release batch of REV2 Carbons has almost completely sold out. You can still place your order now, and you will maintain your place in line.*
**Most new orders are currently slated to ship in March, some sizes are available now, call for details**
- SIZING CHART
- SLACK TEST
- USER MANUAL
Get buckled in your car as if you are ready to race and look straight ahead to the horizon. Have a helper lightly pull any slack from the tether all to one side. Pinch the tether to form a loop and measure the total length of the excess tether. This number should be 1.0-2.0 inches total (about a 1 inch pinch). This is the ideal amount of slack. If it is not 1-2 inches, contact NecksGen for an appropriate length tether for your situation. If you have a REV, tethers are available in one inch increments. If you have a REV2 Lite, simply unscrew the pin that holds the tether to the device and insert it into the appropriate slot for you. Be careful when inserting the pin that it aligns with the back hole in the slot before tightening the screw, and do not overtighten. Finger tight is adequate.